Build Your Own Bed Lamp with Maker UNO

This is a Maker-UNO (Arduino UNO compatible) kit, comes with a tutorial, sample code and also video:

[English]: Colourful Bed Lamp Using Tilt Sensor on Arduino

Utilize the simplicity of Maker UNO and the ease to begin of Arduino Ecosystem, this kit comes with all the necessities to build a bed lamp that change color by just tilting it. The bed lamp uses a tilt sensor to control the color of the light. Without pressing any button, just tilt the lamp until you get your favorite color. The sample code and detailed instructions are in the video and also a tutorial. Estimated to take around 30 minutes to get the electronics up and load the program.

This kit includes the tilt sensor module, just connect the sensor with jumper wires provided to Maker UNO following the respective pins. And the color of the lamp is illuminated by an RGB LED which is also included in the kit :)

Check the tutorial link to get the detailed steps and also sample code to build your bedroom lamp.

• Do It Yourself, Maker UNO (Arduino UNO compatible) Kit
• Comes with all the parts needed
• Simple enough for the beginner as it uses Arduino IDE
• Comes with tutorial, video and sample code

• 1 x Maker UNO: Simplifying Arduino for {Education}
• 1 x USB Micro B Cable
• 1 x Tilt Sensor Module
• 1 x LED 5mm Red Green Blue (4pin)
• 1 x Breadboard Mini(35mmx42mm) - Blue
• 3 x Resistor 0.25W 5% (220R)
• 1 x Male to Male Jumper Wire
• 1 x 40 Ways Male to Female Jumper Wire

• Colorful Bed Lamp Using Tilt Sensor on Maker UNO, tutorial with video, sample code, by Cytron Technologies