micro:bit Smart Cutebot (without micro:bit)

Cutebot is a rear-drive smart car driven by dual high-speed motors. It is mobile robot based on micro:bit controller.

Note: The robot does not include micro:bit, please get it separately.

ELECFREAKS microbit Robot Smart Cutebot is a rear-wheel drive smart car powered by two high-speed motors. Cutebot has a lot of built-in equipment, such as an ultrasonic sensor and a distance sensor, two RGB LED projectors and position lights on the underside, two line tracking sensors, and an active buzzer as a horn. It has rich graphical programming for Cutebot that will help kids learn programming from simple to complex.

Small and cute

The exclusive screen-printed design, smooth edges without burrs, environmentally friendly and safe materials, and playful and cute shapes make the Cutebot microbit robot kit stand out. Start using Cutebot immediately after downloading it, no second installation is required.

High Performance and Explosive Power

Although the body of ELECFREAKS Smart Cutebot Microbit Robot Kit is relatively small and cute, it has strong explosive power and can be used to participate in robot competitions.

Rich Expansion Accessories

It can be connected with other accessory packs, such as octopus sensors.

Rich Onboard Resources

Cutebot includes many built-in functions, such as ultrasonic, rainbow RGB light, RGB frame light, buzzer, infrared receiver, line-tracking sensor, and gimbal wheel.

Fully Enclosed Motor

Cutebot adopts a fully enclosed motor, which will not be damaged due to dust entering.

Support Multiple Programming

Support Makecode, Python, JavaScript, and C++ programming. You can use the ELECFREAKS Smart Cutebot microbit Robot Kit to learn four different programming styles.

Multiple Remote Control Modes

You can use Bluetooth, infrared remote control & Joystick:bit control the car to drive.

• Come ready to kickstart
• Compact mobile robot with micro:bit as controller
• Ready socket for micro:bit and a stackable 3 x AAA battery holder
• Slide switch to ON and OFF the board
• RGB LED as front light for the mobile robot
• Differential drive with left and right micro motor
• Dual infrared sensor at the bottom (front) for line detection and line following
• Ready socket for the HC-SR04 Ultra-sonic Range sensor
• No wiring is needed, just plug and use
• Diameter of mobile robot is < 9cm

• 1 x Cutebot 
• 1 x HC-SR04 Ultrasonic range sensor
• 1 x Printed Manual
• 1 x Battery Holder
• 1 x Foam Tape
• 1 x Line Tracking Map

• CuteBot User Manual, Elecfreacks Wiki page