10Amp 7V-30V DC Motor Driver Shield for Arduino

S$20.71
Cashback: S$0.62
  • 5 or more S$19.68
  • 20 or more S$18.64
  • 50 or more S$16.57
  • Availability: 167

    Buy locally from a partner

    Country:
    Description
    Cytron 10A Motor Driver Shield (Arduino)"SHIELD-MD10" is a compatible Arduino motor shield for controlling high current brushed DC motor up to 10A continuously. It should be stacked on to an Arduino main controller board such as Arduino UNO R3. It is compatible with:
     
     
    This Motor Driver shield uses full solid-state components which results in faster response time and eliminates the wear and tear of the mechanical relay. It has stackable side headers which allow for more Arduino shields to be stacked on top of it. Each shield comes with two mini jumpers for you to select different digital pins for PWM (speed) and DIR (direction), so you can actually stack more shields together.
     
    Note: Starting from July 2015, all Cytron 10A Motor Driver Shield (Shield-MD10) shipped from Cytron are Rev2.0. There is an improvement made. The label changes at the front and back of the shield alike shown in the figure.
     
    arduino motor shield comparison - Front
     
    arduino motor shield comparison - back
     
    ImprovementRev 1.0Rev 2.0
    Ranges of motor voltage supported7V- 25V7V-30V

     

    Warranty Period: 12 months
    Features
    • Bi-directional control for 1 brushed DC motor.
    • Support motor voltage ranges from 7V to 25V (Rev1.0), 7V to 30V (Rev2.0).
    • Maximum current up to 10A continuous and 15A peak (10 seconds).
    • 3.3V and 5V logic level input.
    • Solid-state components provide faster response time and eliminate the wear and tear of mechanical relay.
    • Fully NMOS H-Bridge for better efficiency and no heat sink is required.
    • Regenerative Braking.
    • Speed control PWM frequency up to 10KHz.
    • Stackable I/O header pin.
    • Selectable digital pins for PWM and DIR.
     
    Specifications
    Operating Condition
    Compatible input3.3 and 5V
    Motor Channel1
    Operating Voltage (VDC)5 to 25 (Rev 1.0) 7 to 30 (Rev 2.0 )
    Peak Current (A)15 (10 seconds)
    Continuous Current (A)10
    Operating Modes
    Arduino ShieldYes
    PWM (Lock-Antiphase and Sign-Magnitude)Yes
    UARTNo
    AnalogNO
    RC Servo SignalNo
    Special Protection
    Polarity ProtectionNo
    Appearance
    LEDs IndicatorYes
    Test/Manual ButtonYes
    Cooling FanNo
    Other Features
    othersSelectable PWM and DIR pin
    Packing List
    • 1 x Shield-MD10 (with components soldered and two mini jumpers)
    Q & A (49)

    Ask a question

    Reviews
    • 4.9 out of 5
                    
    • 5
      90.24%
    • 4
      7.32%
    • 3
      2.44%
    • 2
      0%
    • 1
      0%
    Sort By:

    Tags: SHIELD-MD10, Cytron 10A Motor Driver Shield, Robot Controller, 10a, motor, driver, shield, shields, shield-md10 arduino (arduino)